warsfere.blogg.se - Simatic manager copy ram to rom

Right Click On CU310 (or CU320) and Choose… Target Device / Restore Factory Settings Default CU310 or CU320 Open Starter by Motor Icon for Sinamics Open Starter Program & Go Online HW Config must not be Open for Next Section!ĮZ Positioning with SINAMICS S120Basic Starter Online Commissioning.

Correct any errors if they occur Exit the Hardware Configuration.

Hardware Configuration should Save and Compile.

Save and Close Hardware Configuration Press Save an Compile Button

Insert S7 300 Rack, Power Supply, and CPUĪdd Sinamics S120 in Hardware Configuration Drag the drive on to the Profibus Network.

Start Hardware Configuration Click on Hardware Icon and Open HW Configuration Right Click on New Project and insert new Object Choose S7 300 Station New Station inserted -Note Hardware Icon Insert S7 300 Simatic Station Open S7 and Select File / New Select new Name for Project and Press OK Start New Project with S7 Simatic Manager Starter Basic Sinamics Drive Setup Insert Drive (CU310 or CU320) Auto Configure CU and Drive-CLIQ Devices Starter Offline Configuration Drive Configuration Wizard Telegram Setup for EZ _EPOS Block Check S7 Hardware Configuration Execute EZ_EPOS Script File Copy from Example Project Execute and Save Project Download to Sinamics Step7 Simatic Manager Programming Copy Needed blocks to new Program Setup FB120 in new Program Edit Symbol Table Save and Download S7 Project Test EPOS Application on Demo Run through all EPOS Modes with S7 PLC and S120 Demo Sinamics EZ EPOS AgendaĮZ Positioning with SINAMICS S120S7 Hardware Configuration